Tag Archives: astrophotography

imaging system, Spatial Resolution, spectral response

Sampling in Imaging

2 Comments

This article and the following one will discuss the effect on resolution of digitizing a continuous optical image.

The sampling process carried out by the sensor results in digital values corresponding to an intensity at each pixel’s location.  These so-called Data Numbers are stored ideally as-is in the raw file and are proportional to infinitesimal point samples of a new continuous image: the optical image smoothed by the characteristics of the pixels’ effective active area, known as the pixel aperture function.

Figure 1. Simulated Pixel Aperture Function of a 4um pitch Back Side Illuminated pixel in isolation.  Note diffusion beyond the -2/+2um theoretical pixel boundaries suggested by pitch.

Smoothing by a finite pixel area reduces resolution. Continue reading Sampling in Imaging →

IQ, Raspberry Pi, Sensors

Pi HQ Cam Sensor Performance

13 Comments

Now that we know how to open 12-bit raw files captured with the new Raspberry Pi High Quality Camera, we can learn a bit more about the capabilities of its 1/2.3″ Sony IMX477 sensor from a keen photographer’s perspective.  The subject is a bit dry, so I will give you the summary upfront.  These figures were obtained with my HQ module at room temperature and the raspistill – -raw (-r) command:

Raspberry Pi
HQ Camera		raspistill
--raw -ag 1		Comments
Black Level256.3 DN256.0 - 257.3 based on gain
White Level4095Constant throughout
Analog Gain1Gain Range 1 - 16
Read Noise3 e-, gain 1
1.5 e-, gain 16		1.53 DN from black frame
11.50 DN
Clipping (FWC)8180 e-at base gain, 3400e-/um^2
Dynamic Range11.15 stops
11.3 stops		SNR = 1 to Clipping
Read Noise to Clipping
System Gain0.47 DN/e-at base analog gain
Star Eater AlgorithmPartly DefeatableAll channels - from base gain and from min shutter speed
Low Pass FilterYesAll channels - from base gain and from min shutter speed

Continue reading Pi HQ Cam Sensor Performance →

Information Science, IQ, Quantization, Sensors

Sub Bit Signal

Leave a comment

My camera has a 14-bit ADC.  Can it accurately record information lower than 14 stops below full scale? Can it store sub-LSB signals in the raw data?

With a well designed sensor the answer, unsurprisingly if you’ve followed the last few posts, is yes it can.  The key to being able to capture such tiny visual information in the raw data is a well behaved imaging system with a properly dithered ADC.  Continue reading Sub Bit Signal →